KNX / DALI Gateway Twin N 141/31

V Communication via KNX EIB with electronic ballasts (ECG) with a DALI interface
V Two (2) DALI output acc. to IEC 60929‚ each for communication with up to 64 DALI ballasts and at
least 10 sensors
V Integrated power supply with input voltage 110…240 V AC‚ 50…60 Hz or 120…240 V DC for powering
the gateway electronics and DALI output
V Maximum DALI output voltage of 19 V‚ short circuit resistant
V Incorrect voltage detection during commissioning‚ whether incorrect power line is connected to a
DALI output
V LC display for displaying operation mode and error messages
V Pushbutton for switching between bus and direct operating mode
V One pair of push buttons for switching On/Off of all connected DALI ballasts
V One LED per DALI output for status signal of all connected luminaries in direct mode
V Configurable assignment of max. 128 DALI ECG to max. 32 DALI groups‚ exclusive controlled in groups
(switching‚ dimming‚ set dimming value) and feedback for group status and lamp failure
V Configurable behaviour for bus failure (stand-alone mode)
V Control (switching‚ dimming‚ set dimming value) of all connected luminaries together in broad-cast
mode
V Status signal and display of lamp and ECG failure per group and per DALI device
V Possibility to reintegrate defective DALI ECG without software
V One or two level timer
V Integrated scene control for up to 32 scenes
V 16 integrated 2-level-controller for brightness control
V Assignment of DALI ECG to groups and test option for ECG‚ groups and scenes via ETS during commissioning
V Assignment of DALI sensors and test option of sensors via ETS during commissioning
V Integrated bus coupling unit with only half a standard bus load‚ bus connection via bus terminal
V Mounting on DIN rail EN 60715-TH35-7.5